How to Check Recycled Plastic Granule (Dana) Quality: MFI, Density, Moisture and Ash

Recycled plastic granules vary more than virgin polymer, so a few simple checks protect your production line. Here is what to ask for and what each number means.
1. Melt Flow Index (MFI)
MFI shows how easily the melted plastic flows (ASTM D1238 / ISO 1133). Lower MFI means a thicker melt – typical for film and blow moulding. Higher MFI flows more easily – typical for injection moulding. Make sure the MFI suits your process and stays consistent from batch to batch.
2. Density
Density (ASTM D792 / ISO 1183) confirms the polymer type and reveals fillers. LDPE and LLDPE are usually around 0.91–0.93 g/cm³, HDPE around 0.94–0.96 g/cm³ and PP around 0.90–0.91 g/cm³. Unusually high density can indicate filler or mixed material.
3. Moisture
Moisture causes bubbles, streaks and voids. Well-dried granules typically have very low moisture; ask for the moisture value and store bags away from humidity.
4. Ash content
Ash content shows the inorganic residue left after burning – mainly fillers such as calcium carbonate. Low ash usually means cleaner, more consistent material.
5. Colour, gels and contamination
Spread a handful of granules on white paper. Look for uniform colour, black specks, unmelted particles and odour. Run a short machine trial to check for gels and holes in film.
6. Batch documents
Ask for a Technical Data Sheet (TDS) and a Certificate of Analysis (COA) for each batch, so you can compare deliveries over time.